FORMVELD

Visible Mending with Sashiko: A Patch for a Worn Knee

Sashiko began as work stitching. Cloth was scarce, so a garment was reinforced and repaired, layer on layer and stitch over stitch, so that it could go on being worn. Cloth mended that way for long enough has a name: boro. People do this again now and call it visible mending: the repair is not hidden, it becomes part of the garment.

What you need

Patch a worn knee

  1. Prepare. Turn the garment inside out. Trim loose threads around the worn area.
  2. Cut the patch. Make it larger than the damage, so that it reaches at least 2-3 cm (about 1 in) onto sound cloth on every side, and more on a worn knee.
  3. Pin the patch behind the hole with the right side facing the garment's wrong side, so it shows through the hole. Check from the outside that it lies flat, then pin or tack it. On a trouser leg, slip a piece of card inside so you do not stitch the leg closed.
  4. Mark the pattern on the outside of the garment, over the patch and a little beyond it, using one of the transfer methods in the guide above.
  5. Stitch through the garment and the patch. Use running stitches of one grid cell each. For hitomezashi, work the horizontal lines first, then the vertical lines. Leave slack at each turn.
  6. Finish. Secure the thread on the inside and wash out any marks.

Which pattern?

Patterns made of straight, regular lines are the easiest to follow across a patch. Hitomezashi grids and the kikkou (tortoiseshell) hexagon are good first choices; see the names of the traditional Japanese patterns for what the others are called.

More guides